For two RAM sticks on a modern four-slot motherboard, use A2 and B2. That is the usual recommendation. It gives dual-channel memory and tends to leave the most headroom for high-speed kits. Labels and layouts vary by board, so confirm the slots in your motherboard manual before you install.
What A1, A2, B1 and B2 mean
Most four-slot boards group the slots into two channels. A1 and A2 belong to channel A, and B1 and B2 belong to channel B. Within each channel, the “1” slot is usually the one closest to the CPU, and the “2” slot is the next one out. So A2 and B2 are typically the second and fourth slots counting from the CPU socket.
Slot labels vary by vendor. You may see DIMM_A2, DIMMA2, or “Slot 2” on the board. Colors are not standardized, so a matching color pair does not always mean the right pair. The silkscreen on the board and the manual are more reliable.
Why A2 and B2 are usually recommended
Modern boards route memory in a daisy chain. With two sticks installed, the layout is typically tuned for the end slots, A2 and B2. That is why they are the usual choice for high-speed kits, especially at XMP or EXPO speeds. For how those speeds affect stability, see RAM timings and latency.
When A1 and B1 still work
On many boards, A1 and B1 still run in dual-channel mode, so the system works. The problem is headroom. At rated XMP or EXPO speeds, some boards fail to boot in A1 and B1, or they need a lower speed to stay stable.
If your system is stable in A1 and B1 at the speed you want, there is no need to change it. If you run into instability, move the sticks to A2 and B2 as the first thing to try.
Don’t put the sticks side by side
Installing both sticks in A1 and A2 (or B1 and B2) places them on the same channel. That is single-channel memory, which has roughly half the bandwidth of dual-channel. Split the two sticks across channel A and channel B.
One stick, two sticks or four
- One stick: most manuals recommend A2 for a single module. Some boards differ, so check yours. A single stick runs in single-channel mode, which is the trade-off.
- Two sticks: use A2 and B2, or the pair your manual shows.
- Four sticks: fill all four slots. Expect a lower maximum speed, especially with DDR5, because four modules put more load on the memory controller. If you need the kit’s full rated speed, two sticks are the easier route.
For the full range of memory types, form factors and capacities, see the PC RAM guide.
Checking dual-channel in CPU-Z
Open CPU-Z and go to the Memory tab. For DDR4, the channel field reads “Dual” when dual-channel is active. For DDR5, the display depends on the CPU-Z version, and it can read as “2 × 64-bit” or “4 × 32-bit”. Either way, the field should show a dual-channel configuration. If it shows single-channel, move the sticks to the other channel pair and check again.
Before you move the RAM
Shut the PC down, switch off the power supply, and unplug it. Ground yourself against static electricity by touching the metal of the case. Hold each module by its edges, then push it straight down until both latches click. Do not force a module that does not seat easily; check the notch orientation first.
Common misconceptions
- “Put the sticks next to each other.” On most boards, adjacent slots are the same channel, which means single-channel memory.
- “A1 and B1 are correct because they’re first.” A2 and B2 are the usual recommendation on modern boards.
- “If it boots, the slot doesn’t matter.” Slot choice affects stability at rated speed.
- “Same-colored slots always mean a pair.” Color coding is not standardized.