ASUS Performance Enhancement (often shortened to APE) is a BIOS option on many ASUS motherboards. It raises the limits that control how much power and current the CPU can use, so the processor can hold higher clock speeds for longer. It can give a small boost in heavy multi-core work, but it also adds heat and fan noise, so test it before you assume it helps.
What the setting changes
A CPU runs within several limits. The package power limit (PPT) caps total power, and the current limits (TDC and EDC) cap sustained and short-burst current. The stock limits keep the chip inside its design envelope. APE raises those limits above AMD’s defaults on AMD boards, so the CPU can boost higher and for longer before it slows down.
On AMD boards, APE is closely tied to Precision Boost Overdrive (PBO), AMD’s built-in way to raise the same limits. Think of APE as ASUS’s preset for PBO. Some boards also show a manual PBO menu for finer control.
Ryzen 7000 and 9000 CPUs are designed to reach about 95 °C under heavy load (see what TjMax means). A high temperature on its own is not a fault.
Where to find it
Look in Ai Tweaker in Advanced Mode. Press F7 on an ASUS board to switch from EZ Mode. The exact name and options depend on the board and BIOS version, so check your board’s manual if you can’t find it. Older AM4 ASUS boards may show a similar “Performance Enhancer” setting with levels instead.
Does it make your PC faster?
Usually a little, and mostly in multi-threaded work such as rendering, encoding and compiling. Single-thread work and most games see small gains, if any.
The chip and the cooler matter. A CPU that is already held back by temperature or by its cooler will gain little. Community reports on AMD forums are mixed: some users see small gains in certain games, and others see no change or slightly higher temperatures.
Temperature, power and noise
Higher limits mean more heat, more power draw and often louder fans. The benefit depends on cooling. A strong cooler, such as a 240 mm or 280 mm liquid cooler or a large dual-tower air cooler, is the usual recommendation. With a small cooler or a case with weak airflow, the extra power mostly adds heat and noise.
After you enable it, watch temperatures and clock speeds under a full load. HWiNFO and similar monitoring tools show both.
Temperature-limited modes
Some newer ASUS boards offer a version with a temperature ceiling. In one example, the limit is 90 °C. A temperature cap keeps peak heat lower and trades some sustained boost for that. The option names differ by board, so read the BIOS menu carefully.
On Intel boards, ASUS’s similar setting is usually called MultiCore Enhancement (MCE), which removes the power limits. For Intel 13th and 14th generation CPUs, Intel’s default power settings are the safer choice for long-term stability than unlimited MCE.
Should you turn it on?
- Leave it off if your cooler is small, your case has poor airflow, or you care most about quiet operation.
- Test it if you have a good cooler and do heavy multi-core work. Run a stress test such as OCCT or a Cinebench loop, then check for crashes, restarts or temperature spikes.
- If you want more control on AMD, PBO limits can be tuned by hand. This takes time and stability testing, and most people don’t need it.
AMD treats PBO as overclocking, and raising power limits may affect warranty coverage. Check your CPU and board warranty terms before you change them.
How to turn it off or reset it
Set the option to Disabled or Auto. To undo all BIOS tuning at once, press F5 to load Optimized Defaults, then F10 to save and exit. Loading defaults also turns off your memory profile, so turn XMP or EXPO back on afterwards.
For the other settings worth checking, see the BIOS settings guide. Don’t confuse this setting with ErP Ready, which controls standby power. Should you enable ErP in BIOS? covers that one.