To boot from a USB drive once, use the one-time boot menu. Restart, tap the boot-menu key for your board (F8 on ASUS, F11 on MSI or ASRock, F12 on Gigabyte) and choose the USB entry. To change the order permanently, set the device in the Boot tab in BIOS. Most people only need the one-time menu.
The short answer
Plug in the USB drive before you power on. Press the boot-menu key during startup and choose the entry for the drive. If you pick a “UEFI:” entry, the PC boots in UEFI mode, which Windows 11 and most current installers need. To change the order for good, set the drive or your OS drive as Boot Option #1 in the BIOS.
Plug the drive in before you power on
Use a rear USB port wired directly to the board. Front-panel ports sometimes don’t show up in the boot menu. If you are unsure which header a front port uses, see USB 2.0 vs USB 3.0 motherboard headers.
Plug the drive in before you power on or enter the BIOS. If you plug it in after the BIOS has loaded, it may not be listed.
Use the one-time boot menu
Boot-menu keys vary by board:
- ASUS: F8
- MSI: F11
- Gigabyte: F12
- ASRock: F11
- Biostar: F9 on many models
Pre-built PCs use different keys. Dell and Lenovo usually use F12, and HP uses Esc and then F9.
In the menu, pick the “UEFI:
Change the permanent boot order
- Press Delete or F2 at startup to enter the BIOS. Press F7 for Advanced Mode if you’re in EZ Mode.
- Go to the Boot tab and open Boot Option Priorities (or Boot Option #1).
- Pick the device you want first.
- Press F10 to save and restart.
For a one-off boot from inside the BIOS, go to Save & Exit and choose Boot Override, then pick the USB entry.
Once you’ve finished, set Windows Boot Manager or your OS drive back to first, and remove the USB stick. Otherwise the PC may try to boot from the stick every time.
Boot from USB in Windows
If you can’t reach the boot key, you can use Windows instead. Hold Shift and click Restart. Choose Use a device, then pick your USB drive.
When the USB drive doesn’t show up
- Check the drive. Try it in another PC. Some drives are damaged or aren’t bootable.
- Check the format. UEFI boot needs a FAT32 boot partition. For Windows, the Media Creation Tool needs a USB drive of at least 8 GB and erases it. Rufus can make a bootable drive from files larger than 4 GB, using NTFS with UEFI:NTFS.
- Turn off Fast Boot. If the option is on, the BIOS can skip USB devices at startup. Disable Fast Boot or Ultra Fast Boot.
- Check Secure Boot. Secure Boot can block unsigned boot media. Signed Linux distributions boot with it on. See how to enable Secure Boot in BIOS.
- Check the port. Try a rear USB port directly wired to the board.
After a BIOS update or CMOS clear
Boot order can reset after a BIOS update or a CMOS clear. If your PC starts from the wrong device, set the order again. CMOS battery and RTC explains how to clear the CMOS.
Common misreadings
- You don’t need CSM or Legacy mode to boot from USB.
- You don’t have to keep the USB drive first. The one-time boot menu is simpler.
- Boot order doesn’t affect Windows performance once it has loaded.
For the other settings to check after a build, see the BIOS settings guide.