Short answer
USB 2.0 headers are 9-pin blocks (10 positions, with one key pin) and run at 480 Mb/s. USB 3.x headers are 19-pin blocks (20 positions, with a key) and run at 5 Gb/s. Each cable matches its own header type, so do not force one into the other.
The two standards at a glance
| USB 2.0 | USB 3.x (3.2 Gen 1, formerly USB 3.0) | |
|---|---|---|
| Speed | 480 Mb/s | 5 Gb/s |
| Internal header | 9 pins, plus a key pin | 19 pins, plus a key pin |
| Power per port | Up to 500 mA | Up to 900 mA |
| Wires in the cable | 4 | 9 |
| Port colour | Usually black or white | Often blue, but not always |
The internal headers
- USB 2.0 headers usually sit along the bottom edge. Most boards have two to four. Each one usually serves two ports. They are used for front USB 2.0 ports, AIO pumps, RGB and fan controllers, and sometimes a Bluetooth module.
- USB 3.x headers usually sit along the right edge. Most boards have one or two. Each one usually serves two USB-A ports.
- Front USB-C headers have their own connector, often on the right edge. The speed depends on the board, typically 10 Gb/s or 20 Gb/s.
Why they are not interchangeable
The headers have different pin counts and different shapes, and the cable plugs are keyed to one type. A USB 2.0 cable will not fit a USB 3.x header, and a USB 3.x cable will not fit a USB 2.0 header. Pushing one into the other can damage the header or the board.
Do not plug USB cables into other 2 × 5 headers either, such as the serial (COM) header. This can damage the hardware.
Adapters
A 19-pin to 9-pin adapter exists, and it works. However, it limits the ports to USB 2.0 speed.
Speed in practice
A USB 3.x device on a USB 2.0 port runs at USB 2.0 speed. A USB 2.0 device on a USB 3.x port also runs at USB 2.0 speed. To get the full speed, both the port and the device must support USB 3.x.
Finding the right header
- Check the labels on the board. USB 2.0 headers are often labelled USB, F_USB or JUSB. USB 3.x headers are often labelled USB3, U32G1 or similar. Labels vary by brand.
- Check the manual. The manual shows the header type and what each one connects to.
- Check the cable. Front-panel cables are made for one header type. Many cases label each cable.
Colour is not a reliable guide. Blue does not guarantee USB 3.0, so read the label on the board.
Common mistakes
- Forcing the connector. If it does not fit, it is probably the wrong header type. Check the pins.
- Trusting colour. Read the board’s label instead.
- Using a USB 2.0 header for a fast device. It limits the device to USB 2.0 speed.
- Bending the pins. Push and pull the connector straight, holding the plastic housing. The pins on USB 3.x headers bend easily.
- Mixing up the front audio header. It looks similar, but it is keyed differently. Check the manual.
Quick checklist
- Identify the header by its pin count and label.
- Match the cable to the header.
- Check the speed you need, and whether the device supports USB 3.x.
- If you run out of headers, an internal USB 2.0 hub can add ports.
For where the front-panel cables go, see front panel power and reset connectors. For the other parts on the board, see what the components on a motherboard are called.