Build Troubleshooting

What is code 15 on an ASUS motherboard?

ASUS Q-code 15 marks an early memory setup stage. Learn when it is normal on a new PC build and what to check if it stays stuck on that code.

On this page
  1. Is code 15 normal?
  2. What to check if it stays stuck
  3. When it may be more than memory
  4. Common misconceptions
  5. Safety

ASUS Q-code 15 marks an early stage of startup: pre-memory North Bridge (system agent) initialization. The board starts setting up the memory controller here, and on many boards memory training happens around this point. Seeing 15 for a moment during a normal boot is expected. A code that stays on 15 is the problem.

Is code 15 normal?

Often, yes. Code 15 flashes by during normal boots. It can stay on screen longer in a few situations:

  • A new build, where the first boot includes memory training.
  • A system after a BIOS reset or a CMOS clear.
  • A PC with a high-capacity or high-speed memory kit, especially DDR5.

Memory training can take a while. Reports vary a lot, from a few minutes to much longer on large or fast kits. Don’t give up after a short wait. If the PC keeps restarting into 15, or the code never moves on after a long wait, start the steps below.

What to check if it stays stuck

Work through these in order. Power off and unplug the PSU before you touch RAM or the CPU.

  1. Clear CMOS. Use the CMOS clear button or jumper, or remove the CR2032 battery for several minutes. This resets memory settings that may be unstable.
  2. Reseat the RAM and test one stick. Seat each stick until the clips lock. Test one stick in the slot the manual recommends for a single module, often A2. Then try each stick in turn. Check the manual for the right slot pair if you use two sticks.
  3. Run memory at default speed. Turn off XMP or EXPO for now, and enable it only after the PC boots normally.
  4. Update the BIOS. Make sure the BIOS supports your CPU and memory. If the board won’t start with its current BIOS, use the BIOS Flashback feature. It may need the BIOS file renamed, as the manual describes.
  5. Check the CPU and the socket. Reseat the CPU and inspect the pins. On AM5 and LGA sockets the pins are on the board, and on AM4 they are on the CPU. Tighten the cooler screws evenly and to normal tension, so the board and CPU don’t flex.

If one memory kit keeps failing, check the board’s memory QVL (qualified vendor list) for kits known to work with it.

When it may be more than memory

If code 15 still hangs after all of these steps, the RAM, the CPU or the board may be at fault. If you have a known-good stick or kit, test with that. If every known-good part still gets stuck, the board may be faulty. At that point, the DOA diagnosis guide covers the return steps.

For other startup codes and what they can mean, see the motherboard debug LEDs and Q-codes guide. If the PC restarts repeatedly without stopping on a code, see PC turns on and shuts off immediately.

Common misconceptions

  • Code 15 doesn’t mean the motherboard is dead.
  • Q-codes differ between Intel and AMD boards and between BIOS versions. Check your board’s manual.
  • Seeing 15 briefly on every boot is normal.
  • More voltage is not the first fix. Go back to default settings first.

Safety

Power off and unplug the PSU before you reseat RAM or the CPU.

The complete guide to build troubleshooting

Dead Motherboard After a Build? How to Diagnose a DOA Board
Read the guide

Keep exploring

Guides from other topics

All topics →