RGB Lighting

How do I turn off Mobo LED?

How to turn off motherboard LEDs using the BIOS setting, vendor software, and ErP for standby glow, with notes for ASUS, MSI, Gigabyte and ASRock.

On this page
  1. Quick answer: use the BIOS LED setting
  2. Why turning off in software isn’t enough
  3. BIOS LED settings by brand
  4. Software options
  5. Cut standby glow with ErP or Deep S5
  6. Diagnostic LEDs that may stay on
  7. Darken the headers separately
  8. Other options
  9. Safety

Quick answer: use the BIOS LED setting

The most reliable way to turn off motherboard LEDs is the BIOS setting. It works without any software. Some boards have one setting for LEDs. Others have separate settings for when the PC is running and when it is asleep or switched off.

Why turning off in software isn’t enough

Software settings apply while Windows is running. After you shut down, any LEDs that still glow run on 5V standby power, and a software setting can’t stop that.

Uninstalling the RGB software doesn’t turn the LEDs off either. The board goes back to its firmware default, which is often a rainbow pattern.

BIOS LED settings by brand

Menu names and paths vary by BIOS version, so treat these as a starting point:

  • ASUS: Advanced, then Onboard Devices Configuration, then RGB LED Lighting. There are separate settings for the working state and for sleep, hibernate or soft off.
  • MSI: the EZ LED Control toggle, under Settings, in Advanced, or on the top bar. Some boards have a physical EZ LED switch.
  • Gigabyte: “LEDs in System Power On State” and “LEDs in Sleep, Hibernation, and Soft Off States”.
  • ASRock: Advanced, then Onboard Devices Configuration, then RGB LED (On/Off).

Software options

The vendor apps can turn the LEDs off while Windows is running:

  • ASUS: set the lighting to Off in Armoury Crate’s Aura Sync.
  • MSI: set Mystic Light to Off in MSI Center.
  • Gigabyte: set RGB Fusion to Off in GIGABYTE Control Center.
  • ASRock: set the zone or header to Off in Polychrome.

For standby glow after shutdown, you still need the BIOS setting.

Cut standby glow with ErP or Deep S5

Turning on ErP in the BIOS cuts standby power, which turns off the LEDs while the PC is shut down. Some boards call this setting Deep S5 or Deep Sleep. Turning off the PSU switch, or unplugging the PSU, also cuts standby LEDs straight away.

ErP can also stop USB charging and wake-on-LAN while the PC is off, so only turn it on if you don’t need those features.

Diagnostic LEDs that may stay on

Debug LEDs (CPU, DRAM, VGA and BOOT) and POST code displays are diagnostic lights. Most can’t be turned off, though some boards have a setting for them. A small standby light near the 24-pin connector may stay lit whenever the PSU is on. This varies by board.

Darken the headers separately

To darken fans, strips or a hub without touching the board’s own LEDs:

  • Unplug the ARGB or RGB cables from the headers, or
  • Turn them off in the device’s own software.

Unplugging needs the PC off and the PSU switched off first. For the header types, see ARGB and RGB headers.

Other options

OpenRGB can turn off LEDs on many boards without vendor software. Support varies by board and revision.

Safety

Switch off and unplug the PSU before you unplug any internal LED cable.

For brand-specific software, see the guides for ASUS, MSI, Gigabyte and ASRock.

The complete guide to rgb lighting

ARGB and RGB Headers: How to Connect PC Lighting
Read the guide

Keep exploring

Guides from other topics

All topics →